Pull Handles come as a back to back pair unless otherwise stated. Suitable for all joinery. Single handles are available but due to the weight we recommend a rear fixing. Escutcheons and turns are also available under other. See Technical for more information. All of our handles are solid bronze, made and designed in New Zealand.
SLAB PULL HANDLE
Suitable for all joinery, good for narrow style frames with a minimum back set of 30 mm. Available in 3 sizes and custom engraving is available on request.
OFFSET D PULL HANDLE
Suitable for all joinery. Minimum 30 mm back set.
STRAIGHT PULL HANDLE
Our Straight Pull handle comes in 3 different sizes, with a complimentary Slim Straight range which can be used on less prominent doors or windows and cabinetry. We recommend a back set of 40 mm. Suitable for all joinery.
FLAX PULL HANDLE
The Flax Pull handle is a lineal design and requires a minimum back set 57 mm. For double doors we recommend a 65mm back set. If minimum backset is not possible our Offset Plates can be used. All sizes have 130mm hole centers. Suitable for all joinery.
MALIBU PULL HANDLE
A lineal design that requires a minimum back set of 57mm. For double doors we recommend a 65mm back set. If this is not possible use our Offset Plates. All sizes have 130mm hole centers. Suitable for all joinery.
WAVE PULL HANDLE
Wave handles come in 4 sizes. Wave handles are handed, with the belly facing towards the hinges. Allowing more finger room from the door edge. Minimum back set 57mm, posts are at 130mm centers. Suitable for all joinery.
SPRAT PULL HANDLE
Our Sprat Pull Handle comes in 5 different sizes. Recommended back set of 57mm. Suitable for all joinery.
DRIFT PULL HANDLE
Drift Pull Handle comes in 4 sizes, mixed pairs are available with some sizes. All sizes have a 130mm hole centers, minimum back set 57mm. Suitable for all joinery.